![]() Shown in Dark Green, "From" sets the Retract reference position. This is the radius where the tool retracts to between cuts. Shown in Dark Green, this controls the position above the surface you plan to machine. This value is in reference to the centerline of the part and will not recognize any associative changes to the model. Diameter - This option allows you to enter a diameter value in the Offset field.Radius - This option allows you to enter a radius value in the Offset field.Use the Offset parameter to make positive or negative adjustments as needed. Selection - Select any face, vertex, or point on the model to define the Clearance radius.Use the Offset parameter to make adjustments as needed. Stock ID - Sets the Clearance radius in reference to the inside diameter of the Stock, as defined in the Setup.Model ID - Sets the Clearance radius in reference to the inside diameter of the Model, as defined in the Setup.The Clearance radius must be larger than the Inner radius. Inner radius - Sets the Clearance radius in reference to the Inner radius position.The Clearance radius must be larger than the Outer radius. Outer radius - Sets the Clearance radius in reference to the Outer radius position.Model OD - Sets the Clearance radius in reference to the outside diameter of the defined Model.Stock OD- Sets the Clearance radius in reference to the outside diameter of the defined Stock. ![]()
0 Comments
Leave a Reply. |